Partial Discharge at Altitude

July 27, 2021 Laura Wishart

PD is not a simple phenomenon to model as there are many environmental factors that have influence. Factors such as heat, humidity, pressure, are some that can change the voltages required to initiate and extinguish PD within a wire/cable’s insulation. This article specifically discusses the influence of altitude on partial discharge events. The consideration of the operational altitude effect on partial discharge is particularly necessary for aerospace applications as aircraft tend to spend a lot of operating time at high altitudes.

Addressing the Big Questions of Partial Discharge

June 11, 2021 Michael Traskos

In this high-voltage present, wires and cables must address new challenges, perhaps the most notable is partial discharge (also referred to as corona). This article discusses the fundamentals of partial discharge, its impacts on wiring design, and test methods used to assess a component’s partial discharge performance. The PD may occur between (1) the conductor and insulation, (2) within void in the insulation, (3) between insulation layers, or (4) between the insulation surface and shield. Read more

Impact of Corona on Electrical Systems

February 3, 2017 Tristan Epp Schmidt

Corona is an area of electrical systems that many have some knowledge, but often only to the point of knowing that there is a voltage that should not be exceeded. It is common knowledge that factors, such as pressure, have an impact on when and how corona will happen, though the source of corona is […] Read more